스포츠토토 사설 토토사이트 안전놀이터 슬롯사이트 주소 뱃사공 bebe40.com 스포츠중계 수해복구 스가총리 카카오웹툰 미스코리아누드 중국대만 007카지노 로투스게이밍 메이저사이트추천 올인119 온라인라이브카지노

Click here to buy 1202 SKF Bearing

Ready shaft

All components on the shaft are installed between the most positions of the two shafts. If an integral seal is used, this also includes

Includes inside seal.

Install the bearings on both sides of the shaft. For grease lubrication, fill the bearings with grease.

If the shaft is a stepped shaft, install spacers as needed.

Note: The spacer ring is not attached to the bearing seat.

If using integral seals, install the outer seals to both ends of the shaft. If the bearing seat is to be used at the end of the shaft, no seal is required and an end cover is required in the bearing seat.

2. Determine the position of the bearing seat:

If the bearing seat is used for a stepped shaft and the bearing seat hole has a different diameter, the position will be fixed by the diameter of the bearing seat hole

If both sides of the bearing housing have the same diameter, please consider the position of the grease nipple in the top cover. Replenish moisturizing from the side

When sliding self-aligning ball bearings and CARB toroidal roller bearings, the bearing seat must be correctly positioned so that the oil nozzle on the side opposite to the lock nut.

When the bearing seat is at the end of the shaft, the grease nipple on the bottle cap must be on the side of the end cap.

3. Place the bearing seat base on the supporting surface. Install the connecting bolts, but do not tighten them.

If you use a combined seal, insert half of the seal into the seal groove of each bearing seat base.

4. Install the prepared shaft into the bearing seat base. Be careful not to damage the installed seals.

5. If necessary, put a locating ring on each side of the fixed end bearing (using a locating (stabilizing) ring). Make sure that the open end of the positioning ring is facing up.